-
A In order to ensure the long-term stable operation of the molded case circuit breaker, regular inspection and maintenance are required. Check the appearance of the circuit breaker regularly to ensure that there is no damage or deformation. At the same time, keep the circuit breaker clean to prevent dust and dirt from affecting its normal operation. In addition, it is necessary to regularly check whether the mechanical parts such as the contacts and springs of the circuit breaker are worn or loose, and replace or tighten them in time.
-
A When selecting a molded case circuit breaker, factors such as rated current, rated voltage, protection characteristics, and installation methods need to be considered. Select the appropriate rated current and rated voltage according to the actual use to ensure that the circuit breaker can adapt to the load and voltage requirements of the circuit. At the same time, select the appropriate protection type according to the needs, such as overload protection and short-circuit protection. Finally, select a suitable installation method according to the actual installation environment, such as rail installation or panel installation.
-
A When the molded case circuit breaker trips, you first need to check the load in the circuit to confirm whether there is an overload phenomenon. If the load is too large, you need to adjust the load or increase the circuit breaker capacity. Secondly, it is necessary to eliminate the short circuit fault, carefully check each part of the circuit, find out the short circuit point and repair it. If the trip is caused by a ground fault, it is necessary to check the insulation of the equipment and whether the wiring is correct. If the above measures do not solve the problem, it may be that the molded case circuit breaker itself has a fault. It is necessary to check whether the mechanical and electrical parts of the circuit breaker, such as springs, contacts, etc., are normal, and replace the damaged parts in time.
-
A Common types of faults of molded case circuit breakers mainly include overload, short circuit, leakage and mechanical failure. Overload means that the load current exceeds the rated current of the circuit breaker; short circuit means that the two power sources in the circuit are in contact, resulting in excessive current; leakage means that the current flows to the ground through insulation fault or grounding fault; mechanical failure may be a problem with the mechanical parts of the circuit breaker itself, such as loose springs, worn contacts, etc.
-
A Molded case circuit breakers are mainly used to protect circuits from damage caused by faults such as overload and short circuit. It has overload protection and short circuit protection functions. When the current exceeds the set value, the circuit breaker will automatically cut off the circuit to protect the equipment and lines.
-
A Excessive noise from the frame circuit breaker may be caused by the vibration source. The vibration source should be found and eliminated. At the same time, check whether the fasteners are loose. If they are loose, tighten the loose fasteners. In addition, check whether the transmission parts are stuck. If they are stuck, clean and lubricate the transmission parts.
